Dell Force10 C150 Configuration Manual page 162

To view the configuration, use the
Figure 8-21. Command Example: show config in the ROUTE-MAP Mode
FTOS(config-route-map)#show config
!
route-map dilling permit 10
FTOS(config-route-map)#
You can create multiple instances of this route map by using the sequence number option to place the route
maps in the correct order. FTOS processes the route maps with the lowest sequence number first. When a
configured route map is applied to a command, like
route map until a match is found.
Figure 8-22. Command Example: show route-map with Multiple Instances of a Route Map
FTOS#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface
Set clauses:
tag 35
level
FTOS#
To delete all instances of that route map, use the
instance, add the sequence number to the command syntax
Figure 8-23. Deleting One Instance of a Route Map
FTOS(conf)#no route-map zakho 10
FTOS(conf)#end
FTOS#show route-map
route-map zakho, permit, sequence 20
Match clauses:
interface
Set clauses:
tag
level
FTOS#
Figure 8-24
displays only the configuration of the current route map instance. To view all instances of a specific route
map, use the
162 | IP Access Control Lists (ACL), Prefix Lists, and Route-maps
Figure 8-22
GigabitEthernet 0/1
stub-area
GigabitEthernet 0/1
35
stub-area
shows an example of a route map with multiple instances. The
show route-map
command.
show config
command in the ROUTE-MAP mode
redistribute
shows an example with two instances of a route map.
no route-map
(Figure
(Figure
, traffic passes through all instances of that
Route map zakho has two instances
command. To delete just one
map-name
8-24).
show config
8-21).
command