Important Frrp Concepts - Dell Force10 C150 Configuration Manual

• Ring Status Check Frames are transmitted by the Master Node at specified intervals.
• Multiple physical rings can be run on the same switch.
• One Master node is supported per ring. All other nodes are Transit nodes.
• Each node has 2 member interfaces: Primary and Secondary.
• There is no limit to the number of nodes on a ring.
• The Master node ring port states are: blocking, pre-forwarding, forwarding, and disabled.
• The Transit node ring port states are: blocking, pre-forwarding, forwarding, and disabled/
• STP is disabled on ring interfaces.
• The Master node secondary port is in blocking state during Normal operation.
• Ring Health Frames (RHF)
• Hello RHF
— Sent at 500ms (hello interval)
— Transmitted and processed by Master node only
• Topology Change RHF
— Triggered updates
— Processed at all nodes

Important FRRP Concepts

Table 15-1 lists some important FRRP concepts.
Table 15-1. FRRP Components
Concept
Ring ID
Control VLAN
Member VLAN
Port Role
Explanation
Each ring has a unique 8-bit ring ID through which the ring is identified (e.g.
FRRP 101 and FRRP 202 as shown in
Each ring has a unique Control VLAN through which tagged Ring Health
Frames (RHF) are sent. Control VLANs are used only for sending Ring Health
Frames, and cannot be used for any other purpose.
Each ring maintains a list of member VLANs. Member VLANs must be
consistent across the entire ring.
Each node has two ports for each ring: Primary and Secondary. The Master node
Primary port generates Ring Health Frames (RHF). The Master node Secondary
port receives the RHF frames. On Transit nodes, there is no distinction between
a Primary and Secondary interface when operating in the Normal state.
Figure 15-2.
Force10 Resilient Ring Protocol | 339