Create A Policy And Assign A Test And Action List - Dell Force10 C150 Configuration Manual

To add a pre-defined list of actions to your policy action list:
Task
Add a pre-defined list of actions to
your policy action list.
You may add an unlimited number of three types of custom actions:
Task
Execute a recovery action
when FTSA reaches the
test-limit. You may reload the
chassis or reset an RPM or
linecard.
Note: The default test-limit
is unlimited and under this
condition the recovery
action will never execute.
Execute a show debug when
FTSA discovers a test
condition. While debug is
running, FTSA will execute
other pending action list
items.
show
Execute a command
when FTSA discovers a test
condition.
Reset an interface when
FTSA discovers a test
condition.

Create a Policy and Assign a Test and Action List

An FTSA minimally must have a policy test list and policy action list assigned to it.
Step Task
1 Create an FTSA policy and name it.
2 Assign a test list to a policy.
3 Assign a policy action list to a policy.
Command
default-action [ exception | hardware
| software ]
Command
seq number cli-action "command"
seq number cli-debug "debug-command" time seconds
seq number cli-show "show-command" repeat number
delay seconds
seq number interface-reset interface delay seconds
Command Mode
CALLHOME ACTIONLIST
Command Mode
CALLHOME ACTIONLIST
CALLHOME ACTIONLIST
CALLHOME ACTIONLIST
CALLHOME ACTIONLIST
Command Command Mode
policy name
CALLHOME POLICY
test-list name
CALLHOME POLICY
action-list name
CALLHOME POLICY
Force10 Service Agent | 363