Dell Force10 C150 Configuration Manual page 388

Figure 18-5. Inserting and Removing a Line Card
FTOS(conf)#do show linecard all
-- Line cards
Slot Status
---------------------------------------------------------------------------
0 not present
[output omitted]
FTOS(conf)#
FTOS(conf)# do show linecard
-- Line cards
Slot Status
---------------------------------------------------------------------------
0 online
[output omitted]
FTOS(conf)#%RPM0-P:CP %CHMGR-2-CARD_DOWN: Line card 0 down - card removed
FTOS(conf)#do show linecard
-- Line cards
Slot Status
---------------------------------------------------------------------------
0 not present
[output omitted]
Pre-configure a line card slot
You may also pre-configure an empty line card slot with a logical line card using the command
from CONFIGURATION mode. After creating the logical line card, you can configure the interfaces on
the line card as if it is present, as shown in
Figure 18-6. Configuring a Logical Line Card
FTOS(conf)#do show linecard 0
-- Line card 0 --
Status
FTOS(conf)#int gig 0/0
% Error: No card configured in slot at "^" marker.
FTOS(conf)#linecard 0 E48VB
FTOS(conf)#do show linecard 0
-- Line card 0 --
Status
Required Type : E48VB - 48-port GE 10/100/1000Base-T line card with RJ45 interfaces and PoE
(CB)
FTOS(conf)#int gig 0/0
FTOS(conf-if-gi-0/0)#
388 | High Availability
--
NxtBoot ReqTyp
%RPM0-P:CP %CHMGR-5-CARDDETECTED: Line card 0 present
all
--
NxtBoot ReqTyp
online E48VB
all
--
NxtBoot ReqTyp
E48VB
: not present
^
: not present
CurTyp Version
CurTyp Version
E48VB 7-5-1-71
CurTyp Version
Figure 18-6.
Ports
Ports
48
Ports
linecard