Dell Force10 C150 Configuration Manual page 344

Step Command Syntax
interface primary int
3
slot/port secondary int
slot/port control-vlan
vlan id
mode transit
4
member-vlan vlan-id
5
{range}
no disable
6
Set FRRP Timers
Step Command Syntax
timer
1
{hello-interval|dead-interval}
milliseconds
Clear FRRP counters
Use one of the following commands to clear the FRRP counters.
Command Syntax
clear frrp
344 | Force10 Resilient Ring Protocol
Command Mode
CONFIG-FRRP
CONFIG-FRRP
CONFIG-FRRP
CONFIG-FRRP
ring-id
Purpose
Assign the Primary and Secondary ports, and the
Control VLAN for the ports on the ring.
Interface:
• For a 10/100/1000 Ethernet interface, enter
the keyword keyword
followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the
keyword
slot/port information
• For a SONET interface, enter the keyword
sonet
• For a 10 Gigabit Ethernet interface, enter the
keyword
the slot/port information.
Slot/Port: Slot and Port ID for the interface.
VLAN ID: Identification number of the Control
VLAN
Configure a Transit node
Identify the Member VLANs for this FRRP
group
VLAN-ID, Range: VLAN IDs for the ring's
Member VLANs.
Enable this FRRP group on this switch.
Command Mode Purpose
CONFIG-FRRP Enter the desired intervals for Hello-Interval or
Dead-Interval times.
Hello-Interval: 50-2000, in increments of 50
(default is 500)
Dead-Interval: 50-6000, in increments of 50
(default is 1500)
The Dead-Interval time should be set at 3x the Hello-Interval.
Command Mode Purpose
EXEC PRIVELEGED Clear the counters associated with this Ring ID
Ring ID: 1-255
GigabitEthernet
GigabitEthernet
followed by the
followed by slot/port information.
TenGigabitEthernet
followed by