Apply The Method List To Terminal Lines; Specify A Radius Server Host - Dell Force10 C150 Configuration Manual

Command Syntax
aaa authorization exec
default
{ |
method-list-name
tacacs+

Apply the method list to terminal lines

To enable RADIUS AAA login authentication for a method list, you must apply it to a terminal line. To
configure a terminal line for RADIUS authentication and authorization, enter the following commands:
Command Syntax
line aux 0 console 0 vty number
{ | |
[ ]}
end-number
login authentication
{
method-list-name
default
}
authorization exec
methodlist

Specify a RADIUS server host

When configuring a RADIUS server host, you can set different communication parameters, such as the
UDP port, the key password, the number of retries, and the timeout.
To specify a RADIUS server host and configure its communication parameters, use the following
command in the CONFIGURATION mode:
Command Syntax
radius-server host
{
hostname
|
ipv4-address ipv6-address
auth-port port-number retransmit
[ ] [
timeout seconds
] [ ] [
retries
[ ] ]
encryption-type key
Command Mode
CONFIGURATION
radius
}
Command Mode
CONFIGURATION
LINE
|
CONFIGURATION
Command Mode
| CONFIGURATION
}
key
Purpose
Create methodlist with RADIUS and TACACS+ as
authorization methods. Typical order of methods:
RADIUS, TACACS+, Local, None. If authorization is
denied by RADIUS, the session ends (
be the last method specified).
Purpose
Enter the LINE mode.
Enable AAA login authentication for the specified
RADIUS method list. This procedure is mandatory if
you are not using default lists.
To use the methodlist.
Purpose
Enter the host name or IP address of the RADIUS server
host. Configure the optional communication parameters
for the specific host:
auth-port port-number
•
UDP port number. The default is 1812.
retransmit retries
• range: 0 to 100. Default is 3.
timeout seconds
• range: 0 to 1000. Default is 5
seconds.
key
• [ ]
encryption-type key:
for encrypted text, and a string for the key. The key
can be up to 42 characters long. This key must match
the key configured on the RADIUS server host.
If these optional parameters are not configured, the
global default values for all RADIUS host are applied.
radius
should not
range: 0 to 65335. Enter a
Enter 0 for plain text or 7
Security | 929