Power supply
6.4
Replacing the power supply module
Customer Replaceable Units (CRU)
Average task duration: 5 minutes
V
CAUTION!
When replacing a power supply module in a non-redundant
●
configuration, the server must be switched off first.
Replace the power supply module after specifying the one that
●
breaks down at work by revitalization.
Both power supply modules must be of the same type.
●
6.4.1
Required tools
Preliminary and concluding steps: tool-less
●
Main steps: tool-less
●
6.4.2
Preliminary steps
Perform the following procedures:
Ê Only when replacing a power supply module in a non-redundant
configuration:
Ê Check which power supply module is defective.
A power supply module is defective when the indicator on the PSU module
lights up yellow.
I
For more information see section
page
208.
86
"Shutting down the server node" on page 41
Upgrade and Maintenance Manual
"Power supply module" on
CX400 S1