Removing The Server Enclosure Out Of The Rack - Fujitsu PRIMERGY CX400 S1 Upgrade And Maintenance Manual

4.3.3

Removing the server enclosure out of the rack

V
CAUTION!
At least two people are needed to lift the server out of the rack cabinet.
For the Japanese market, according to the following procedures.
If you remove the CX400 S1 server enclosure out of the rack, remove all
HDD, PSU and Server Node from the server enclosure.
In addition, at least two people are needed when server enclosure is
installed in the height of 25U or more.
(For the Japanese market, please refer to " 安全上のご注意 ".)
Applies only to EMEA market as follows
CX400 S1
For configurations below 32 kg:
At least two people are needed to lift the server
out of the rack cabinet.
For configurations below 55 kg:
At least three people are needed to lift the server
out of the rack cabinet.
For configurations above 55 kg:
At least four people are needed to lift the server
out of the rack cabinet.
Upgrade and Maintenance Manual
Basic hardware procedures
45