Opening Electrical Circuit To Cutting Units; Electrical Drawings - Toro Greensmaster TriFlex 3320/3420 Service Manual

Opening Electrical Circuit to Cutting Units

CAUTION
Before installing, removing or servicing the cut-
ting units, separate the cutting unit power dis-
connect. This will prevent unexpected cutting
unit operation.
Before installing, removing or working on the cutting
units, disconnect the cutting units from the electrical
power supply by separating the cutting unit power dis-
connect couplers (Fig. 1). The couplers are located at
the base of the rollover bar on the left side of the traction
unit. Connect the couplers together before operating the
machine.

Electrical Drawings

The electrical schematic and wire harness drawings for
Greensmaster TriFlex Hybrid 3320 and 3420 machines
are located in Chapter 10 -- Foldout Drawings.
Greensmaster 3320/3420
2
1. Coupler
Page 6 - - 3
1
Figure 1
2. Stationary coupler
Electrical System