Reel Motor Adapter - Toro Greensmaster TriFlex 3320/3420 Service Manual

Reel Motor Adapter

Removal
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. Remove the electric reel motor from the cutting unit
(see Cutting Reel Motors in the Service and Repairs
section of Chapter 6 -- Electrical System). Move motor
to storage location on front of cutting unit suspension as-
sembly.
3. Remove reel motor adapter from cutting unit side
plate using Fig. 27 as a guide.
4. Remove O--rings as necessary from motor adapter
(Fig. 28).
Installation
1. If large O--ring was removed from flange of motor
adapter, lubricate O--ring with grease. Small O--rings
should be installed into motor adapter without lubrica-
tion. Make sure that O--rings are correctly positioned in
grooves in adapter.
2. Install reel motor adapter to cutting unit side plate us-
ing Fig. 27 as a guide.
3. Secure electric reel motor to the cutting unit (see Cut-
ting Reel Motors in the Service and Repairs section of
Chapter 6 -- Electrical System).
Greensmaster 3320/3420
1. Hex nut
2. Reel motor adapter
3
1. Adapter
2. O- -ring
Page 8 - - 27
4
1
2
3
Figure 27
3. Socket head screw
4. Motor clamp
2
Figure 28
3. O- -ring
DPA Cutting Units
1