Generator Assembly (Greensmaster 3420) - Toro Greensmaster TriFlex 3320/3420 Service Manual

Generator Assembly (Greensmaster 3420)

24
23
22
1
29
70 to 80 in- -lb
(8.0 to 9.0 N- -m)
1. Generator assembly
2. Square key
3. Generator pulley
4. Square head screw (2 used)
5. Generator plate
6. Flange head screw (5 used)
7. Washer (2 used)
8. Torsion spring
9. Idler bracket
10. Retaining ring
11. Grease fitting
NOTE: If electrical problems exist with the generator
assembly, a fault should have occurred that would be in-
dicated by a flashing diagnostic light on the console (se-
rial number below 312000000) or fault indicator on the
InfoCenter (serial number above 312000000). Before
considering that generator service work is necessary,
check for any existing fault codes that indicate problems
with the generator.
Electrical System
18
12
19
16
26
13
15
21
5
24
4
2
33
Figure 106
12. Generator belt
13. Flange nut
14. Idler pulley spacer
15. Flange head screw (5 used)
16. Bell housing
17. Flange nut (5 used)
18. Engine pulley
19. Lock nut (2 used)
20. Coupling flange
21. Rear engine mount
22. Thrust washer (2 used)
Page 6 - - 90
20
14
30
28
30
17
6
7
27
25 90 to 110 in- -lb
(10.2 to 12.4 N- -m)
3
23. Cap screw (2 used)
24. Flange head screw (6 used)
25. Washer
26. Flange head screw (5 used)
27. Cap screw
28. Idler pulley
29. Generator guard
30. Dirt exclusion washer (2 used)
31. Flange bushing (2 used)
32. Engine assembly
33. Washer head screw (4 used)
Removal (Fig. 106)
1. Park machine on a level surface, lower cutting units,
stop engine, apply parking brake and remove key from
ignition switch.
32
10
7
31
9
31
8
RIGHT
FRONT
Greensmaster 3320/3420
11