Toro Greensmaster TriFlex 3320/3420 Service Manual page 267

Disassembly (Fig. 13)
1. Park machine on a level surface, engage the parking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
2. Remove screws (item 12) that secure console cover
(item 2) to console. Lower cover to allow access to con-
sole components.
3. Remove components from control console as need-
ed using Figure 13 as a guide.
4. Disassemble functional control lever assembly as
needed using Figure 14 as a guide.
5. Disassemble joystick assembly as needed using
Figure 15 as a guide.
NOTE: The alarm (item 15) is used on machines that
are equipped with the Turf Guardian
System.
NOTE: Refer to Chapter 6 -- Electrical System for infor-
mation regarding electrical components on console.
Assembly (Fig. 13)
1. If functional control lever assembly was disas-
sembled, assemble control lever using Figure 14 as a
guide.
2. If joystick assembly was disassembled, assemble
joystick using Figure 15 as a guide. If finger spring wash-
ers (item 7 in Fig. 15) were removed, position washers
so that fingers on washer point towards pivot hub.
3. Install all removed components to control console
using Figure 13 as a guide.
4. Position console cover (item 2) to console and se-
cure with screws (item 12).
Greensmaster 3320/3420
TM
Leak Detector
1. Console
2. Pivot tube
3. Functional lever
4. Split bushing
5. Cap screw
6. Flat washer
7. Lock nut
8. Roller pivot
9. Bushing
10. Flat washer
11. Spring spacer
12. Torsion spring
13. Flat washer
14. Lock nut
15. Bearing spacer (2 used)
16. Bearing
1. Joystick rod
2. Jam nut
3. Joystick bracket
4. Switch (2 used)
5. Screw (2 per switch)
6. Spacer
7. Finger spring washer
Page 7 - - 17
1
29
5
28
17
16
15
21
8
3
2
FRONT
22
Figure 14
14
13
7
10
12
11
10
Figure 15
27
31
32
25
30
23
24
9
10
11
12
4 13
6
14
7
18
19
20
26
17. Lock nut
18. Spring pin
19. Ball joint
20. Neutral lock cable
21. Lock nut
22. Cable clamp
23. Neutral switch
24. Knob
25. Mow switch
26. Screw (2 used)
27. Screw (2 used)
28. Lock nut (2 used)
29. Clip (2 used)
30. Lever bracket
31. Jam nut (4 used)
32. Lock washer (4 used)
1
2
3
4
5
6
7
8
9
8. Flat washer
9. Cap screw
10. Bushing
11. Pivot hub
12. Torsion spring
13. Speed nut (2 used)
14. Lock nut
Chassis