Toro Greensmaster TriFlex 3320/3420 Service Manual page 247

4. Locate and unplug two (2) electrical connectors from
motor cable to machine wire harness.
5. Route motor cable out of wire form on cutting unit
suspension.
6. Remove cutting reel motor from the cutting unit:
A. Push the motor clamp out of the slots on the mo-
tor mount toward the cutting unit sideplate (Fig. 111).
B. Slide cutting reel motor from cutting unit (Fig.
112).
7. If necessary, remove two (2) retaining rings that se-
cure motor mount (item 4) to reel motor. Remove motor
mount from motor.
Installation (Fig. 109)
1. If motor mount was removed from motor, position
motor mount to cutting reel motor flange and secure with
two (2) retaining rings.
2. Install cutting reel motor to the cutting unit:
A. Coat splines of cutting reel motor shaft with clean
grease.
B. Align cutting reel motor shaft splines with splines
in cutting reel. Slide reel motor into cutting unit side
plate (Fig. 112).
C. Pull motor clamp toward the motor until clamp ful-
ly engages slots on both sides of the motor mount
(Fig. 113). There should be an audible click as clamp
engages mount.
3. Route motor cable through wire form on cutting unit
suspension and then to machine wire harness connec-
tors.
4. Secure motor cable to brackets on machine with two
(2) bulkhead nuts.
5. Plug two (2) motor cable electrical connectors into
machine wire harness.
6. After completing installation of all cutting unit motors,
connect the cutting unit power disconnect couplers.
Greensmaster 3320/3420
1
2
1. Cutting reel motor
2. Motor clamp
1
1. Cutting reel motor
2. Motor clamp
1
2
1. Cutting reel motor
2. Motor clamp
Page 6 - - 97
3
Figure 111
3. Cutting unit sideplate
3
2
Figure 112
3. Cutting unit sideplate
3
Figure 113
3. Cutting unit sideplate
Electrical System