Toro Greensmaster TriFlex 3320/3420 Service Manual page 271

Disassembly (Fig. 18)
1. Park machine on a level surface, engage the parking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
2. Disconnect the cutting units from the electrical power
supply by separating the cutting unit power disconnect
couplers (see Opening Electrical Circuit to Cutting Units
in the General Information section of this chapter).
3. Remove grass basket from suspension assembly.
4. Remove cutting unit from suspension assembly (see
Traction Unit Operator's Manual).
5. Disassembly crossarm assembly as required using
Figure 18 as a guide.
NOTE: The flange head screws (item 13) used to se-
cure the basket horn (item 12) to the crossarm assembly
have a patch lock to prevent loosening of the screws. If
screws are removed, replace screws.
Greensmaster 3320/3420
Assembly (Fig. 18)
1. Assemble crossarm assembly using Figure 18 as a
guide.
2. Install cutting unit to suspension assembly (see
Traction Unit Operator's Manual).
3. Install grass basket.
4. Connect the cutting unit power disconnect couplers.
Page 7 - - 21 Chassis