Rear Roller Brush (Optional) - Toro Greensmaster TriFlex 3320/3420 Service Manual

Rear Roller Brush (Optional)

Antiseize
Lubricant
70 to 80 in- -lb
(8 to 9 N- -m)
12
5
3
12
26
19
20
25
RIGHT RIGHT
FRONT FRONT
1. Cover
2. Drive belt
3. Drive pulley
4. Pulley driver
5. Cap screw
6. Idler pulley assembly
7. Cover plate
8. Flange nut (5 used)
9. Drive plate
NOTE: Drive components for the rear roller brush are
located on the right side of the cutting unit.
DPA Cutting Units
1
2
12
10 11
6
21
22
9
18
24
10. Driven pulley
11. Square key
12. Threadlock screw (4 used)
13. Roller bearing assembly (2 used)
14. Grease fitting (2 used)
15. LH brush support
16. Flange head screw (4 used)
17. Brush assembly
18. O- -ring
130 to 140 in- -lb
(15 to 16 N- -m)
14
23
7
8
4
100 ft- -lb
(136 N- -m)
Figure 38
NOTE: The Installation Instructions for the rear roller
brush kit has detailed information regarding assembly
and adjustment. Use those Instructions along with this
Service Manual when servicing the rear roller brush.
Page 8 - - 32
17
8
16
19. Flat washer
20. Bearing spacer
21. Spacer
22. Cap screw
23. Bearing spacer
24. Hex nut (2 used)
25. Weight
26. Cap screw (2 used)
Greensmaster 3320/3420
13
15