General Information
Operator's Manuals
The Traction Unit and Cutting Unit Operator's Manuals
provide information regarding the operation, general
maintenance procedures and maintenance intervals for
your Greensmaster machine. Refer to these publica-
tions for additional information when servicing the ma-
chine.
Check Hydraulic Fluid Level
The hydraulic system on your Greensmaster machine is
designed to operate on high quality hydraulic fluid.
Check level of hydraulic fluid daily. Refer to Traction
Unit Operator's Manual for fluid level checking proce-
dure and hydraulic oil recommendations.
Pushing Traction Unit
In case of emergency, your Greensmaster can be
pushed for a very short distance. However, Toro does
not recommend this as a standard procedure.
1. Make sure that engine is not running.
2. Locate by--pass valve on piston (traction) pump (Fig.
2). Rotate by--pass valve so slot is vertical.
IMPORTANT: Do not push the machine faster than
2 mph because the traction system may be dam-
aged. If machine must be moved a considerable dis-
tance (more than a few feet), transport it on a truck
or trailer.
3. Slowly push machine.
4. Before starting engine, rotate by--pass valve so slot
is horizontal. Do not start engine when by--pass valve is
in the vertical position.
Hydraulic System
1. Hydraulic reservoir
1. Piston (traction) pump
Page 5 - - 4
Figure 1
2. Fuel tank
Figure 2
2. By- -pass valve
Greensmaster 3320/3420
1
2
1
2