Grooming Reel (Forward Rotating Groomer Drive) - Toro Greensmaster TriFlex 3320/3420 Service Manual

Grooming Reel (Forward Rotating Groomer Drive)

100 ft- -lb
(135 N- -m)
17
18
4
1
2
20
16
21
1. Lock nut (4 used)
2. Drive cover
3. Groomer drive belt
4. Drive pulley
5. Shoulder bolt (2 used)
6. Spring
7. RH drive plate assembly
8. Groomer shim
9. RH groomer arm assembly
Remove the grooming reel to replace individual blades,
to replace worn groomer components, to reverse the
blades on the shaft (if not equipped with carbide blades)
or to replace the grooming shaft.
Removal (Fig. 8)
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
Groomer
25
8
6
7
19
1
5
3
9
10
Figure 8
10. Cap screw (2 used)
11. Bushing (2 used)
12. Spring washer (2 used)
13. Lock nut (2 used)
14. LH support plate
15. LH groomer arm assembly
16. Special washer (2 used)
17. Rear roller height shim
18. Socket head screw (4 used)
Page 9 - - 10
26
22
23
13
12
11
17 to 21 ft- -lb
(24 to 28 N- -m)
2. Disconnect the cutting units from the electrical power
supply by separating the cutting unit power disconnect
couplers (see Opening Electrical Circuit to Cutting Units
in the General Information section of this chapter). This
will prevent unexpected cutting unit operation.
3. Remove the cutting unit from the machine and place
cutting unit on a flat work area.
4. If equipped, remove rear roller brush from cutting
unit (see Rear Roller Brush Removal in the Service and
Repairs section of Chapter 8 -- DPA Cutting Units).
14
27
11
12
13
Antiseize
Lubricant
24
RIGHT
FRONT
19. Driven pulley
20. HOC screw (2 used)
21. HOC nut (2 used)
22. Plow bolt (2 used)
23. Grooming reel assembly
24. Front roller assembly
25. RH cutting unit sideplate
26. LH cutting unit sideplate
27. O- -ring
Greensmaster 3320/3420
15