CLUTCH AND PRIMARY DRIVE GEAR
1
1. Oil filter cover bolt
2. Oil filter outer cover
3. Air filter housing bracket
4. Cap bolt
5. Cap
6. O-ring
7. Oil filter
2
7. Remove the clutch cover from the crankcase.
Watch for the dowels (A, Figure 3) behind the
cover. Remove the dowels.
8. Remove and discard the clutch cover gasket (B,
Figure 3).
9. Inspect the clutch cover for cracks and other
signs of wear. Replace the cover if necessary.
CLUTCH COVER
8. Clutch cover bolt
9. Wire clamp
10. O-ring
11. Clutch cover
12. Gasket
13. Dowel
3
10. Installation is the reverse of removal. Note the
following:
a. Install the two dowels (A, Figure 3) and a
new gasket (B) into the crankcase.
b. Install the air filter housing bracket behind
the two bolts (B, Figure 2) noted during re-
moval.
169
6