Panasonic DBS 824 Manual page 133

Before You Begin
Initializing New Systems
Before programming a newly installed DBS 824 system, set its programs to
the default values by performing the following procedure
Important: This procedure must be performed prior to programming the
DBS 824 for the first time
Card) may cause operational problems
This initialization procedure can also be used when you want to return all
changed programs to the default values
1 Power-off the DBS 824 (set power switch to OFF)
2 Slide the CPC s SW1 switch to RAMCLEAR
Figure 1
3 Power-on the DBS 824, then wait until the bottom status LED on the
4 Slide SW1 to the RAMHOLD position
Intro-4
Battery
Slot 2
CPC card stopsflashing (approximately IO seconds)
DBS 824-l O-400
Introduction to DBS 824 Programming
Failure to initialize the CPC (Central Processing
Status LED
CAUTION.
Some early CPC cards
have RAM HOLD and
RAM CLEAR reversed
Check the silk screen
RAM HOLD
RAM CLEAR
CAUTION:
Setting SW 1 to
RAM CLEAR Erases
Issued 3/l /95