Co-To-Co Talk Mode Control - Panasonic DBS 824 Manual

Hide thumbs Also See for DBS 824:

Table of Contents

CO-to-CO Talk Mode Control

Software Version CPC-S and CPC-M, Version 1 0 and higher

Address FFl 2# l# 38## (0 or l)#

Use this address to determine whether the DBS 824 system will use an

internal conference circuit for trunk-to-trunk conference calls or whether it

will connect the trunks directly

The CO-to-CO Talk mode is entered via the Call Forward-Outside feature or

the DISA Outgoing function If an audio loop-back problem occurs when

trunks are connected directly, reset this program address to "Use a conference

Related Programming

Automatic DISA Callers

Unsupervised Conference Timer FFl 3# 9# (0-15)#

Unsupervised Trunk Conference

Unsupervised Conference

up to three conference circuits at a time If this programming address is set to

"1" (use a conference circuit), and a fourth CO-to-CO call is attempted while

three other conference calls are currently in progress, the system will connect

the trunks in the fourth call directly to each other

Issued 3/l/95

1 =Use a conference circuit.

FF3 (ExtPort)# 13# (0 or l)#

DBS 824-10-400

CO-to-CO Talk Mode Control

Table of Contents