External Page Interface Control For Paging Groups - Panasonic DBS 824 Manual

External Page Interface Control For Paging Groups

Software Version
Address
Description
This setting determines whether a page is heard over an external page device
connected to the 824 This device is normally a loudspeaker installed
ceiling and connected to the 824 via the "EPA" phono-jack (for audio path)
on the CPC-S and CPC-M cards On the CPC-M card, a device can also he
connected to the CN4 relay
heard on the speakers of extension phones in the page group selected
External paging, however, is controlled by the setting of this address If
external paging is activated an audio path is established
phono-jack on the CPC card (for both CPC-S and CPC-M versions) whenever
a page is initiated The following also happens in a CPC-M configuration 1)
the "M2", "B2" and ' C2 ' relay terminals are activated when any page group
is selected for the page, and 2) the 'Z" relay terminals activate when their
Address
2
3
4
6
7
8
9
Related Programming
Page Group Extensions FF3 (ExtPort)# (18-25)# (0 or l)#
EPI Audio Control (CPC-S Only) FFl 2# I# 37# (0 or l)#
Issued 3/l /95
External Page Interface Control For Paging Groups
CPC-S and CPC-M, Version 1 0 and higher
Page Group'
(see table below)
0
2
3 23 relay activated
4
No relay control
5
for these
6
7 page
DBS 824-l O-400
labeled "AZ", "Zl", 'Z2", 23" and
terminals
can be connected
paging only
1 =Extemal and
(see table below)
CPC M Only
are activated.
in the
the "EPA"
via
paging
Internal
CPC-M CPC S
and
Audio path is
phmo jack on the CPC
C a r d
l-57