Panasonic DBS 824 Manual page 454

Terminal Programming
Terminal Programming Through a CO or DISA Trunk
Note: To enter the Terminal Programming mode through a trunk, the DBS
824 must be equipped with an MFR card and an external modem
To program through a CO or DISA trunk
1 Dial into the DBS 824 through the trunk
2 Ask the operator to dial the following command (this will switch the
3 Ask the operator to transfer you to the SLT extension number that is
4 After the DBS 824 displays the "Remote Programming" banner screen on
5 Follow the directions on the screen to access the desired program
Terminal Programming Commands
Use the following commands to navigate terminal programming
Table B-l Terminal programming commands
B-2
system to the "Maintenance" mode)
connected to the modem
the computer, type P then press ENTER
Access Ring assignments
-05 Access F'F key assignments
Access Name assignments
-06
-07 Access Toll Restriction data
-08 Access Least Cost Routing data
-09
-10 Access Speed Dial data
Back to previous address
- F Forward to next address
- f Forward to next port
DBS 824-l O-400
Appendix B
1
Issued 3/l /95