Loop-Start Trunks; Guidelines; Installation; Lines - Panasonic DBS 824 Manual

Trunks and Lines

Loop-Start Trunks

Guidelines

The following procedure covers loop-start trunk installation using the main
l
and expansion RJ14 trunk connectors
For pinouts and color codes for the trunk connectors, see Figure 4-2
l
1
2

Lines

Extension Connectors

The number of extension ports on your system depends on the number of 208
EXP cards installed in the DBS 824
Table 4-1 summarizes the number of extension ports for each configuration
of extension ports
Table 4-1 Total number
Number of 208 EXP
(VB-42050) Cards
0
1
2
Issued 3/l/95
If using trunks 5 and 6, ensure that a 208 EXP card in the leftmost 208
slot If using trunks 7 and 8, ensure that a 208 EXP card is installed in the
second 208 sIot (Note A CPC-M card is required when using the second
208 EXP See Chapter 3 for circuit card installation )
card
Connect the trunks from the MDF to the RJ14 trunk connectors CN7 and
EXP card installed as shown in Figure 4-l and Figure 4-2
Total
Extension Ports
8
16
2 4
DBS 824-l O-300
Loop-Start Trunks
Notes
Install in leftmost 208
slot"
4 - 5