Trunk Circuit Type - Panasonic DBS 824 Manual

Trunk Circuit Type

Trunk Circuit Type
Software Version CPC-M Only (Version 1 0 and above)
Address FF2 (Trunk)# 21# (0 or l)#
Description
This program determines whether a trunk circuit in a CPC-M configuration is
loop-start, or if it will support Caller ID
In a CPC-S configuration (which does not support Caller ID), all trunks are
loop-start
Programming
Notes
CPC Card Requirement. This program address does not apply to the CPC-S
model, which does not support Caller ID (Caller ID is a service offered by
local COs, that sends caller information to the DBS 824 system for incoming
calls )
Power-Cycling Requirement For changes to this parameter to take effect,
the system must be turned off and back on
2-l 8
FF2 (l-8)# 21# (0 or l)#
Trunk Number
CPC-M 1-8
DBS 824-l O-400
l=Supports Caller ID
Issued 3/l /95
FF2