Panasonic DBS 824 Manual page 137

Default Program Settings
2 Press [FFl]
4 Press 1
5 From the keypad, enter the new date in the following format
6 Press # to store the program change Then press the [ON/OFF] key to exit
Default Program Settings
The following table shows the default settings for all DBS 824 program
addresses Some of these addresses contain number ranges which are shown
in parentheses These are the acceptable ranges for trunk numbers, extension
ports, etc in a CPC-M configuration with two 208 Expansion Cards In the
following chapters of this Programming section, the address explanations will
also show the acceptable number ranges for the CPC-S configuration with
one 208 Expansion Card
Table 2 Default program settings
Address
Intro-8
( System Program
is displayed on line 2)
SUB MODE
is displayed on line 2)
# ( A
D TE SET MODE
is displayed on line 2)
YEAR
Enter month as MM
Enter date as DD
Enter year as YY
programming mode, the new date is displayed on all phones with an LCD
Day/Date Setting
Time Setting
Call Duration Display
SMDR Start Timer for CO Calls
Least Cost Routing (LCR) Access
Override Toll Restriction With SSD Numbers
SSD Display Restriction
DBS 824-l O-400
Introduction to DBS 824 Programming
is displayed on line 1,
is displayed on line 1
is displayed on line 1,
Program
SELECT
1 DATE 2 TIME
/ /
MONTH DAY
Default
Sun JAN 1
12 00
Displayed
Begins after 5 set
Pooled trunk
No TRS override
SSD digits are
Issued 3/l /95