Chapter 3 Setup
Update procedure
1. Press the [Browse] button to select an image file used for update.
2. Pressing the [Start Update] button starts update.
3. You can check the progress of update by viewing message displayed on Update Status field. When
update completes, "Update completed" is displayed.
Important
Buttons
① [Browse] button
Press the [Browse] button to select an image file used for update.
② [Apply immediate]
When the server is in power-off state, or server is in power-on state and [Apply immediate] is being checked,
BMC is reset automatically 60 seconds after completion of update.
③ [Start update] button
Press the [Start update] button to start update.
④ [Reload] button
Press the [Reload] button to display the latest information.
Important
380
•
If update is performed while the DC power is off, BMC is reset 60 seconds later
and restarted with new firmware regardless of the checkmark on "Apply
immediate" check box.
•
If update is performed while the DC power is on, BMC is reset automatically at
next power-off of server, and restarts with the new firmware.
•
Clear the cache of the Web browser after the update completed.
The Security Warning of Java as shown below may appear when update is started. In
this case, be sure to select [Don't Block]. If you select [Block], update will fail.
To hide popup message as shown below, select [Control Panel] → [Java] →
[Advanced] → [Mixed Code (sandbox vs. trusted) security verification], and check to
[Enable - hide warning and run with protections].
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
7. Using Remote Management