NEC express5800 A2010b User Manual page 432

Chapter 3 Setup
oemnec_l2cache=3840KB
oemnec_l3cache=38400KB
Verbs:
cd
exit
help
show
version
Confirming Memory Information
Enter the following command at the command prompt to move the current default target to /admin1/system1.
cd /admin1/system1
You can confirm all the targets for memory (DIMM) by entering the following command. All the memory (DIMM)
targets are represented as memory<N> strings at "Targets" section. <N> means value of one-origin integer. The
maximum value of <N> is 64.
show
Next, when the following command is entered, information of a specific memory (DIMM) slot target is displayed
at "Properties" section. Here, <N> means memory (DIMM) slot target number which you would like to confirm. 1
to 8 memory slots are displayed.
show memory<N>
The EnabledState property of the memory target indicates the memory (DIMM) status.
"2" indicates that memory (DIMM) is installed.
"3" indicates that memory (DIMM) is disabled.
If no memory (DIMM) is installed, nothing is displayed as a target.
The values of the properties not supported by the server are not displayed.
For example, enter the following command to confirm the information of memory1 (MR1_DIMM1).
show memory1
The display example in this case is shown below.
ufip=/admin1/system1/memory1
Properties:
enabledstate=2
oemnec_slotname=MR1_DIMM1
oemnec_clocksize=8192MB 1066MHz
Verbs:
cd
exit
help
show
version
432
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
8. SMASH-CLP