Setup For Solving Problems; Setup For Memory Dump (Debug Information); Acquiring User-Mode Process Dump; Installing Network Monitor - NEC express5800 A2010b User Manual

Chapter 3 Setup
2.4

Setup for Solving Problems

Perform the following setup procedure preliminarily to recover from a failure quickly and reliably when a failure
occurs.

2.4.1 Setup for Memory Dump (Debug Information)

This setup is required for collecting a memory dump (debug information) in the server. The memory dump
(debug information) is used for fault analysis when a system failure occurs.
Refer to Installation Guide (Windows) stored in EXPRESSBUILDER for details.

2.4.2 Acquiring User-Mode Process Dump

The user-mode process dump file records information when an application error occurs.
Refer to Installation Guide (Windows) stored in EXPRESSBUILDER for details.

2.4.3 Installing Network Monitor

Install the network monitor to investigate and manage network troubles.
Refer to Installation Guide (Windows) stored in EXPRESSBUILDER for details.

2.4.4 Setup for Alert Notification

The server provides two types of alert notification methods, SNMP Trap and Email.
(1)
Mail Alert
Alert is sent via Email. Up to six destinations can be specified. To use Email alert, settings for Destination and
SMTP Server are required.
See Chapter 3 (7.7.1 BMC – (3) (a) Email Alert) for details.
(2)
SNMP Alert
Alert is sent via SNMP.
See Chapter 3 (7.7.1 BMC – (3) (b) SNMP Alert) for details.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
2. Setup
253