Network Settings - NEC express5800 A2010b User Manual

Chapter 3 Setup
8.11

Network Settings

This section describes how to confirm the network setting for management LAN through the command line
interface. Enter the following command at the command prompt to move the current default target to
/admin1/sp1/enetport1.
cd /admin1/sp1/enetport1
Enter the following command to confirm properties of the Ethernet port.
show
The properties which the Ethernet port target contains are as follows:
•
PermanentAddress
Shows the BMC MAC address at the right side of "PermanentAddress=" string. This property is read-only.
•
AutoSense
This indicates whether Auto Negotiation is enabled for the Connection Type of Ethernet port. Note that, the
valid values for this property are "TRUE" and "FALSE". "TRUE" means that the Auto Negotiation is enabled.
"FALSE" means that the Auto Negotiation is disabled.
•
FullDuplex
This indicates whether Full Duplex Mode is enabled for the Connection Type of Ethernet port when the Auto
Negotiation (AutoSense) is disabled (FALSE). Note that, the valid values for this property are "TRUE" and
"FALSE". The value of this property is not displayed when the Auto Negotiation (AutoSense) is enabled
(TRUE). This property is read-only.
•
PortType
This indicates Link Speed ("10BaseT" or "100BaseTX") for the Connection Type of Ethernet port when the
Auto Negotiation (AutoSense) is disabled (FALSE). The value of this property is not displayed when the
Auto Negotiation (AutoSense) is enabled (TRUE). This property is read-only.
To modify the access limitation via network, enter the following command at the command prompt to move the
current default target to /admin1/sp1/enetport1/lanendpt1.
cd /admin1/sp1/enetport1/lanendpt1
Enter the following command to confirm properties of the access limitation target.
show
Enter the following command to modify a property of the access limitation target.
set <property>=<new value>
The properties that can be viewed and modified are as follows:
•
oemnec_allowedaccessips
This specifies the IP addresses that permit access from the network. Divide IP addresses by "," (ex.
192.168.1.2, 192.168.1.2, ...) or use asterisk (ex. 192.168.1.*), if you would like to set multiple permit IP
address. Set "0.0.0.0" or no <value> (*) to this property, if you would like to clear the value of this property. It
becomes effective at next login if you change it. The value of this property is cleared if
oemnec_deniedaccessips is set.
* When not specifying any value, use [Enter] key next to "=" as shown below:
set oemnec_allowedaccessips=[Enter]
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
8. SMASH-CLP
425