NEC express5800 A2010b User Manual page 427

Chapter 3 Setup
Example: To enable DHCP setting
set AddressOrigin=4
To confirm the gateway setting, enter the following command at the command prompt to move the current
default target to /admin1/sp1/enetport1/lanendpt1/ipendpt1/gateway1.
cd /admin1/sp1/enetport1/lanendpt1/ipendpt1/gateway1
Enter the following command to confirm properties of the gateway target.
show
The properties which the gateway target contains are as follows:
•
InfoFormat
"InfoFormat=3" is displayed. This indicates the AccessInfo is IPv4 address. This property is read-only.
•
AccessInfo
This specifies the IP address of the default gateway for the network. This property is read-only.
To configure the network when DHCP is disabled, enter the following command at the command prompt to
move the current default target to /admin1/sp1/enetport1/lanendpt1/ipendpt1/staticipsettings1.
cd /admin1/sp1/enetport1/lanendpt1/ipendpt1/staticipsettings1
Enter the following command to confirm properties of the network setting target.
show
Enter the following command to modify a property of the network setting target.
set <property>=<new value>
The properties which the network setting target contains are as follows:
•
oemnec_FloatingIPv4Address
This specifies the IP address (floating IP address) for BMC when DHCP is disabled. This is the dynamic
setting.
•
IPv4Address
This specifies the IP address for BMC (RMCP+ address) when DHCP is disabled. This is the dynamic
setting.
•
SubnetMask
This specifies the subnet mask for BMC when DHCP is disabled. This is the dynamic setting.
•
GatewayIPv4Address
This specifies the IP address of the default gateway for BMC when DHCP is disabled. This is the dynamic
setting.
To modify the HTTP service, enter the following command at the command prompt to move the current default
target to /admin1/sp1/httpsvc1.
cd /admin1/sp1/httpsvc1
Enter the following command to confirm properties of the HTTP service target.
show
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
8. SMASH-CLP
427