Diagnostic Displays - ABB ACS550 User Manual

ACS550 User's Manual
Diagnostics
WARNING! Do not attempt any measurement, parts replacement or other service
procedure not described in this manual. Such action will void the warranty, may
endanger correct operation and increase downtime and expense.
WARNING! All electrical installation and maintenance work described in this chapter
should only be undertaken by qualified service personnel. The safety instructions in
chapter

Diagnostic displays

The drive detects error situations and reports them using:
• the green and red LED on the body of the drive
• the status LED on the control panel (if an Assistant Control Panel is attached to
the drive)
• the control panel display (if a control panel is attached to the drive)
• the Fault Word and Alarm Word parameter bits (parameters 0305 to 0309). See
Group 03: FB ACTUAL SIGNALS
The form of the display depends on the severity of the error. You can specify the
severity for many errors by directing the drive to:
• ignore the error situation
• report the situation as an alarm
• report the situation as a fault.
Red – Faults
The drive signals that it has detected a severe error, or fault, by:
• enabling the red LED on the drive (LED is either steady on or blinking)
• showing the steady red status LED on the control panel (if attached to the drive)
• setting an appropriate bit in a Fault Word parameter (0305 to 0307)
• overriding the control panel display with the display
of a fault code in the Fault mode (figures on the
right)
• stopping the motor (if it was on).
The fault code on the control panel display is
temporary. Pressing any of the following keys removes
the fault message: MENU, ENTER, UP, or DOWN key.
Safety on page 5 must be followed.
on page 104 for the bit definitions.
LOC
243
LOC
FAULT
FAULT 8
AI1 LOSS
00:00
F0008
FWD
Diagnostics