How To Perform The Id Run; Id Run Procedure - ABB ACS550 User Manual
Hide thumbs
Also See for ACS550:
- Quick start manual (2 pages) ,
- Quick start up manual (139 pages) ,
- Installation supplement manual (16 pages)
Table of Contents
Advertisement
ACS550 User's Manual
How to perform the ID Run
The drive estimates motor characteristics automatically using identification
magnetization when the drive is started for the first time and after any motor
parameter
9910
• parameter
• parameter
5 (
In most applications there is no need to perform a separate ID Run
1 (
ON
• vector control mode is used [parameter
2 (
• the operation point is near zero speed, and/or
• operation at torque range above the motor nominal torque over a wide speed
range and without any measured speed feedback is required.
Note: If motor parameters
Run, it must be repeated.
ID Run procedure
The general parameter setting procedure is not repeated here. For Assistant Control
Panel see page
WARNING! The motor will run at up to approximately 50...80% of the nominal speed
during the ID Run. The motor will rotate in the forward direction. Ensure that it is
safe to run the motor before performing the ID Run!
De-couple the motor from the driven equipment.
Check that the values of the motor data parameters
the motor nameplate, as shown in the steps on page 33.
If parameter values
before the ID Run, check that the new settings meet the following conditions:
2001
MINIMUM SPEED
2002
MAXIMUM SPEED
2003
MAXIMUM CURRENT
2017
MAX TORQUE
use according to parameter
Check that the Run Enable signal is on (parameter 1601).
Ensure that the panel is in local control (LOC shown on the left / at the top). Press key
switch between local and remote control.
(Group 99: START-UP
ID RUN has value 0 (OFF/IDMAGN), and
9904
= 1 (
VECTOR
9904
= 3 (
SCALAR
+
).
FLY
BOOST
)]. The ID Run should be selected if:
:
)], and/or
VECTOR
TORQ
(Group 99: START-UP
49
and for Basic Control Panel page
(Group 01: OPERATING DATA
< 0 rpm
> 80% of the motor rated speed
> I
2hd
1 > 50% or
2018
2014
MAX TORQUE SEL
DATA) is changed. This is valid when parameter
:
) or 2 (
SPEED
VECTOR
:
) and parameter
FREQ
9904
= 1 (
PRE-CHECK
9905...9909
to
Group 98:
2 > 50%, depending on which limit is in
MAX TORQUE
.
:
), or
TORQ
2101
= 3 (
SCALAR FLYST
[9910
:
) or
VECTOR
SPEED
DATA) are changed after the ID
67
in chapter
Control
are equivalent to those on
OPTIONS) are changed
Start-up, control with I/O and ID Run
39
) or
=
ID RUN
panels.
to
LOC
REM
Hide quick links:
Advertisement
Table of Contents
