Alarm Codes (Basic Control Panel) - ABB ACS550 User Manual

ACS550 User's Manual
Alarm
code
2027
2028
Note 1. Even when the relay output is configured to indicate alarm conditions (e.g. parameter

Alarm codes (Basic Control Panel)

The Basic Control Panel indicates control panel alarms with a code, A5xxx. The
following table lists the alarm codes and descriptions.
Code
5001
5002
5010
5011
5012
5013
5014
5015
5018
5019
5020
5021
5022
5023
5024
5025
5026
5027
5028
5029
5030
5031
5032
5040
5041
5042
5043
5044
Display
This alarm warns that the condition defined by parameter 3701
USER LOAD
CURVE LOAD C MODE
3703
Shown during the Start delay. See parameter 2113
START DELAY
1401 1 = 5 (
RELAY OUTPUT
output.
Drive is not responding.
The communication profile is incompatible with the drive.
The panel's parameter backup file is corrupted.
Drive is controlled from another source.
Rotation direction is locked.
Button is disabled, because start is inhibited.
Button is disabled, because drive is faulted.
Button is disabled, because local mode lock is on.
Parameter default value can't be found.
Writing a non-zero value is prohibited (can only write a zero value).
Group or parameter does not exist or parameter value is inconsistent.
Group or parameter is hidden.
Group or parameter is write protected.
Modification is not allowed while the drive is running.
Drive is busy, try again.
Write is not allowed while upload or download is in progress.
Value is at or below low limit.
Value is at or above high limit.
Value is invalid – doesn't match any values in the discrete values list.
Memory is not ready, try again.
Request is invalid.
Drive is not ready, e.g due to low DC voltage.
Parameter error was detected.
Selected parameter set can't be found in the current parameter backup.
Parameter backup doesn't fit into memory.
Selected parameter set can't be found in the current parameter backup.
No start inhibit was granted.
Parameter backup versions do not match.
Description
has been valid longer than half of the time defined by
.
USER LOAD C TIME
) or 16 ( / )), this alarm is not indicated by a relay
ALARM FLT ALARM
Description
253
USER
.
START DELAY
Diagnostics