Id Run With The Assistant Control Panel; Id Run With The Basic Control Panel - ABB ACS550 User Manual

40
Change parameter
by pressing SAVE
If you want to monitor actual values during the ID Run, go to
the Output mode by pressing
there.
Press to start the ID Run. The panel keeps switching
between the display that was shown when you started the ID
Run and the alarm display presented on the right.
In general, it is recommended not to press any control panel
keys during the ID Run. However, you can stop the ID Run at
any time by pressing
After the ID Run is completed, the alarm display is not shown
any more.
If the ID Run fails, the fault display presented on the right is
shown.
Change parameter
by pressing
If you want to monitor actual values during the ID Run, go to
the Output mode by pressing
there.
Press to start the ID Run. The panel keeps switching
between the display that was shown when you started the ID
Run and the alarm display presented on the right.
In general, it is recommended not to press any control panel
keys during the ID Run. However, you can stop the ID Run at
any time by pressing
After the ID Run is completed, the alarm display is not shown
any more.
If the ID Run fails, the fault display presented on the right is
shown.
Start-up, control with I/O and ID Run

ID RUN WITH THE ASSISTANT CONTROL PANEL

9910 to 1 (
ID RUN ON
.
EXIT repeatedly until you get
.

ID RUN WITH THE BASIC CONTROL PANEL

9910 to 1 (
ID RUN ON
.
repeatedly until you get
.
). Save the new setting
). Save the new setting
ACS550 User's Manual
LOC PAR EDIT
9910 ID RUN
ON
[1]
CANCEL 00:00 SAVE
LOC 50.0Hz
0. 0 Hz
0. 0 A
0. 0 %
DIR 00:00 MENU
LOC ALARM
ALARM 2019
ID run
00:00
LOC FAULT
FAULT 11
ID RUN FAIL
00:00
9910
LOC
PAR FWD
1
LOC
PAR SET FWD
00
LOC
.
OUTPUT FWD
A2019
LOC
FWD
F0011
LOC
FWD
Hz