How To Set The Speed, Frequency Or Torque Reference; How To Adjust The Display Contrast - ABB ACS550 User Manual

48

How to set the speed, frequency or torque reference

Step Action
1. If you are not in the Output mode, press
2. If the drive is in remote control (REM shown on the status line), switch to local
control by pressing
the mode and then returns to the Output mode.
Note: With Group 11: REFERENCE
modification in remote control.
3. • To increase the highlighted reference value shown in the top right corner of the
display, press
permanent memory and restored automatically after power switch-off.
• To decrease the value, press

How to adjust the display contrast

Step Action
1. If you are not in the Output mode, press
2. • To increase the contrast, press keys
• To decrease the contrast, press keys
Control panels
EXIT
. The display briefly shows a message about changing
LOC
REM
SELECT, you can allow the reference
. The value changes immediately. It is stored in the drive
.
EXIT
MENU
and
MENU
and
repeatedly until you get there.
repeatedly until you get there.
simultaneously.
simultaneously.
ACS550 User's Manual
Display
REM 49.1Hz
49. 1 Hz
0. 5 A
10. 7 %
DIR MENU
00:00
49.1Hz
LOC
49. 1 Hz
0. 5 A
10. 7 %
DIR 00:00 MENU
LOC 50.0Hz
50. 0 Hz
0. 5 A
10. 7 %
DIR 00:00 MENU
Display
LOC 49.1Hz
49. 1 Hz
0. 5 A
10. 7 %
DIR 00:00 MENU
LOC 49.1Hz
49. 1 Hz
0. 5 A
10. 7 %
DIR 00:00 MENU