Applicable Standards; Ce Marking; C-Tick Marking - ABB ACS550 User Manual

ACS550 User's Manual

Applicable standards

Drive compliance with the following standards is identified by the standard "marks"
on the type code label.
Mark

CE marking

A CE mark is attached to the drive to verify that the drive follows the provisions of the
European Low Voltage and EMC Directives (Directive 73/23/EEC, as amended by
93/68/EEC, and Directive 89/336/EEC, as amended by 93/68/EEC).
Note: The 600 V ACS550-U1 drives are not CE approved.
Compliance with the EMC Directive
The Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. The EMC product standard [IEC/EN
61800-3 (2004)] covers requirements stated for drives.
Compliance with IEC/EN 61800-3 (2004)
See page 293.

C-Tick marking

The drive carries C-Tick marking.
C-Tick marking is required in Australia and New Zealand. A C-Tick mark is attached
to the drive to verify compliance with the relevant standard (IEC 61800-3 (2004) –
EN 50178 (1997)
IEC/EN 60204-1 (2005)
IEC/EN 60529 (2004)
IEC 60664-1 (2002)
IEC/EN 61800-5-1 (2003) Adjustable speed electrical power drive systems.
IEC/EN 61800-3 (2004)
IEC/EN 61800-3 (2004)
UL 508C
C22.2 No. 14
Applicable standards
Electronic equipment for use in power installations
Safety of machinery. Electrical equipment of machines.
Part 1: General requirements. Provisions for compliance: The
final assembler of the machine is responsible for installing:
• an emergency-stop device
• a supply disconnecting device.
Degrees of protection provided by enclosures (IP code)
I
nsulation coordination for equipment within low-voltage
systems. Part 1: Principles, requirements and tests
Part 5-1: Safety requirements. Electrical, thermal and energy
Adjustable speed electrical power drive systems.
Part 3: EMC requirements and specific test methods
Adjustable speed electrical power drive systems.
Part 3: EMC requirements and specific test methods
UL Standard for Safety, Power Conversion Equipment, third
edition
CSA Standard for Industrial Control Equipment (for ACS550-U1
drives only)
291
Technical data