Siemens Sinumerik 840C Diagnostics Manual page 150

1 Alarms
1.5.1 Alarm description
146420 "G%1: only one rotary axis allowed"
146421 "G%1: 2 or 3 axes are expected"
146422 "G%1: Thread pitch parameter = 0"
146423 "G36: C is plane axis but G%1 is selected"
146430 "G%1: no pole defined yet"
146431 "G%1: negative radius illegal"
146432 "G%1: programmed axis is not a pole axis"
146433 "G%1: more than 2 axes programmed"
146434 "G%1: program either axis or radius"
146435 "G%1: program either axis or angle"
146436 "G%1: pole definition with G90 is missing"
146437 "G%1: pole definition only with exactly 2 axes"
146438 "G%1: G91 only allowed for existing pole axes"
146439 "G%1: no radius in block"
146440 "G%1: negative radius illegal"
146441 "G%1: no angle in block"
146442 "G%1: G91 for angle only allowed after G90"
146443 "G%1: more than one radius programmed"
146444 "G%1: more than one angle programmed"
146450 "G%1: no axes programmed"
146451 "Rapid trav. for contour definit'n not allowed"
146452 "G%1: sequence/number of elements illegal"
146453 "Only positive radius allowed here"
146454 "Progr. elements do not form a trav. block"
146455 "Contour definition: no further axis possible"
146456 "Contour definition: more than 2 axes progr."
146457 "G%1: G935 must be programmed with G1"
146458 "Contour definition: faulty circle parameters"
146459 "Contour def.: circle param. progr. sev. times"
146460 "No further circular axis possible"
146461 "Faulty circle parameters"
146470 "G16: at least 2 axes expected"
146471 "G%1: plane axes are identical"
146472 "G16: max. 4 axes can be simulated"
146480 "Axis prog. –> C axis on/off ignored"
146481 "M19 S: other M functions ignored"
1–142

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96