Siemens Sinumerik 840C Diagnostics Manual page 154

1 Alarms
1.5.1 Alarm description
160004 Data code ... , error ... , 0x ...
Scan
Startup application
Effect
Undefined
Explanation
Internal system error with stated error parameters
Remedy
Terminate application and repeat procedure, notify service if necessary.
160005 Function code ... , error ... , 0x ...
Scan
Startup application
Effect
Undefined
Explanation
Internal system error
Remedy
Terminate application and repeat procedure, notify service if necessary.
160006 File transfer ID ... , error ... , 0x ...
Scan
Startup application
Effect
Undefined; measuring data lost
S
Explanation
Internal system error
S
File transfer error when reading out a measurement buffer with specified error parameters.
Remedy
Check MMC system configuration and hardware
160007 Measurement/drive type combination not allowed
Scan
When starting measuring functions
Effect
The selected function is not started
Explanation
The selected function is not possible with the addressed drive type
Remedy
None
160008 Mode/drive type combination not allowed
Scan
When starting measuring functions
Effect
The selected function is not started
Explanation
The selected function is not possible with the addressed drive type.
Remedy
None
160009 Mode/signal type combination not allowed
Scan
When starting measuring functions
Effect
The selected function is not started
Explanation
The selected signal type is not available
Remedy
Correct signal selection
160010 Too many function generators operating
Scan
When function generator is started
Effect
Function generator is not started
Explanation
Only function generator at a time can be active
Remedy
Stop active function generator and repeat procedure
1–146

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey