Siemens Sinumerik 840C Diagnostics Manual page 179

04/96
01/99
165027 Loading from on-line to on-line not possible
Scan
Loading MD files
Effect
Function is not executed
Explanation
Only user or STANDARD data can be loaded
Remedy
–
165028 BOOT is no valid file name
Scan
Edit new, editing, saving, inserting MD files
Effect
Function is not executed
Explanation
The name cannot be used for user files
Remedy
Enter a different name.
165029 Boot files cannot be loaded
Scan
Loading MD files
Effect
–
Explanation
Boot files are automatically loaded on NCK reset
Remedy
–
165030 There is no file with power section selection
Scan
Drive MD/module selection
Effect
Power section cannot be selected
Explanation
There is no system file
Remedy
Please notify Siemens Service
Note
Applies as from SW 4
165031 No communication to the MSD
Scan
Saving, loading machine data
Effect
Function is not executed
Explanation
Transmission either not possible or transmission interference
Remedy
Repeat operation
Note
Applies for SW 3 only
165032 MSD has not taken any standard values
Scan
Drive MD, spindle (MSD): select motor
Effect
Drive is not parameterized
Explanation
There are no standard data for this motor/PS combination
Remedy
Select a different motor or motor from another manufacturer
165033 Conversion has not been switched off
Scan
Loading drive machine data
Effect
Illegal data in drive
Explanation
The alarm can also occur when drive MD are being transmitted if a boot file already exists.
Remedy
Repeat operation, press softkey "General reset" in the initial clear mode and reload the drive data.
Note
Applies as from SW 5.4.

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
1–171