Siemens Sinumerik 840C Diagnostics Manual page 66

1 Alarms
1.5.1 Alarm description
3164 Axis conversion error
S
Scan
While executing in AUTOMATIC, MDA or Teach In mode
S
Effect
Machining stops
S
Interlocking of NC START
S
Explanation
The alarm is displayed in channel and block.
S
Wrong entries in axis converter list (SD)
– Axis name not entered
– Axis does not exist
Remedy
Correct axis converter list
Note
Alarm is displayed with reference to block and channel
3166 Program coordination wrong
Scan
While executing a part program
S
Effect
Machining stops
Explanation
Addressed channel has not been defined or is not enabled
Remedy
Change channel addressing
Define or enable channel
Note
Alarm is displayed with reference to block and channel
3167 T/H word not acknowledged
Scan
Cyclic
Effect
None
S
Explanation
The target channel is not enabled in the PLC MD (signals from channel)
S
Routing in target channel has not yet been acknowledged by the user
Remedy
The current routing and/or error must be acknowledged through the PLC program before the next routing is assi-
gned.
3200 Program coordination syntax wrong
Scan
When executing a part program
Effect
Interlocking of machining
Explanation
Syntax error: invalid command mnemonics
invalid modification parameters
Remedy
Correct the faulty command
Note
Alarm is displayed with reference to block and channel
3201 Program coord. too many parameters
Scan
When executing a part program
Effect
Interlocking of machining
Explanation
More command parameters have been programmed than are permitted in the command description.
Remedy
Correct the faulty command
Note
Channel-specific
3202 Program coordination area violation
Scan
When executing a part program
Effect
Interlocking of machining
Explanation
One or more command parameters violate the permitted lower and upper limit values
Remedy
Correct the faulty command
Note
Alarm is displayed with reference to block and channel
1–58

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
07/97 07/97
Acknowledgement key
Acknowledgement key
Acknowledgement key
Acknowledgement key
Acknowledgement key
Acknowledgement key