Siemens Sinumerik 840C Diagnostics Manual page 153

04/96
146709 "Block with @711: too much info. in block"
146730 "Axis not allowed here –> ignored"
146731 "IPO parameters not allowed here –> ignored"
146732 "Radii not allowed here –> ignored"
146733 "Angle not allowed here –> ignored"
146734 "F word not allowed here –> ignored"
146735 "M words not allowed here –> ignored"
146736 "S word not allowed here –> ignored"
146737 "T word not allowed here –> ignored"
146738 "H word not allowed here –> ignored"
146739 "D word is not allowed here –> ignored"
146740 "Comments not allowed here"
146741 ":–word not allowed here –> ignored"
146742 "Only @714 allowed here. Other @ ignored"
146743 "@706/@715/@720 not allowed here –> ignored"
146744 "Progr. coord. [...] illegal here –> ignored"
146745 "L word not allowed here –> ignored"
146746 "N word not allowed here –> ignored"
146747 "P word not allowed here –> ignored"
160001 Axis already assigned
Scan
On "START"
Effect
The selected function is not started
Explanation
No further startup functions can be started with the defined axis number
Remedy
Terminate the startup function already active for this axis
160002 Axis not configured or configured wrongly
Scan
Startup application
Effect
Startup function is not executed
Explanation
Selected axis is not available
Remedy
Select available axis
160003 Drive module is not configured or incorrectly
Scan
Startup application
Effect
Startup function is not executed
Explanation
Selected drive number is not available
Remedy
Select available drive module

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
OK softkey
OK softkey
OK softkey
1–145