Siemens Sinumerik 840C Diagnostics Manual page 167

04/96
160101 Internal error, end startup
Scan
Startup application
Effect
–
Explanation
Startup application cannot be executed because of internal error
Remedy
No startup application or end startup application
160102 Memory area exceeded
Scan
Start-up application at start of neural quadrant error compensation
Effect
The function cannot be started
Explanation
Fine quantization * (coarse quantization +1) must be less than or equal to 1000
Remedy
Reduce the size of fine and coarse quantization
Note
Applies as from SW 4
160103 Invalid address assignment
Scan
Start-up application at start of neural quadrant error compensation
Effect
The function cannot be started
Explanation
Error in the parameterization of limit lower or upper area
Remedy
Correct inputs
Note
Applies as from SW 4
160104 Learning phase active file functions not possible
Scan
Start-up application at file functions in the neural quadrant error compensation
Effect
Access to the file functions not possible
Explanation
No file functions are allowed while measurement is taking place
Remedy
Stop measurement or wait for end of measurement
Note
Applies as from SW 4
160105 QEC bits not set
Scan
Start-up application at start of neural quadrant error compensation
Effect
The function cannot be started
Explanation
The activation bit of the neural QEC (NC MD) is not set
Remedy
Set QEC bits
Note
Applies as from SW 4
160106 Feedforward control not activated
Scan
Start-up application at start of neural quadrant error compensation
Effect
The function cannot be started
Explanation
The speed feedforward control must be activated
Remedy
Activate speed feedforward control (option, NC MD, PLC bit)
Note
Applies as from SW 4
160107 Axes not configured
Scan
Start-up application at start of circle form test
Effect
The function cannot be started
Explanation
Two real axes must be configured
Remedy
Configure axes
Note
Applies as from SW 4

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
1–159