Siemens Sinumerik 840C Diagnostics Manual page 234

1 Alarms
1.6.2 Listing of dialog texts
SPECIFY 2 PROGRAM
NUMBERS
STOP AXES
STOP PROGRAM
TOO MANY
CHARACTERS ENTERED
TOOL NUMBER NOT
ALLOWED
RS232C (V.24) CHANNEL
ALREADY IN RESET
RS232C (V.24) CHANNEL
NUMBER NOT CORRECT
WRONG AXIS
SPECIFIED
WRONG DATA NUMBER
WRONG G FUNCTION
WRONG MODE GROUP
WRONG PASSWORD
WRONG RS232C (V.24)
CHANNEL NUMBER
WRONG VALUE
ENTERED
"–" NOT ALLOWED
"=", "CR" IN WRONG
PLACE
1ST NUMBER > 2ND
NUMBER
2ND DECIMAL POINT
1–226
Dialog text
Appears with the
following event
When copying or renaming
part programs
The actual axis value is to
be read
Editing the program being
processed
Taking over an input value
(e.g. with the input key)
With functions operating
with tool offsets
On stop or stop all in
display
Data input/output
When starting data
input/output
With axis-specific functions
(e.g. Preset)
When deleting data
With technology-
dependent functions
For functions which are
assigned to a mode group
(e.g. channel selection)
Password input
Starting data output
When inputting into display
screen forms (e.g. contour
definition)
Taking over an input value
(e.g. with the input key)
Taking over an input value
(e.g. with the input key)
Deleting data areas
Taking over an input value
(e.g. with the input key)
END OF SECTION

Siemens AG 2001 All rights reserved 6FC5198–jAB40
What must be done
What is wrong
––
Axis values must not
change.
Interrupt program
(NC STOP)
Input value has the wrong
format
e.g. PRESET with a rotary
axis: In the PRESET
display "0" must be
entered for the tool offset
number
A RESET request has
already been sent. When
the softkey is pressed
again it is ignored.
The RS232C (V.24)
interface number is too
large or too small
Axis does not exist
Data item (e.g. R
parameter) with the
number entered does not
exist
Correct G function
Select an alternative mode
group
–
The RS232C (V.24)
interface number is too
large or too small
Change value
Input value has wrong
format
Input value has the wrong
format
The 1st number must be
smaller than the 2nd
Input value has the wrong
format
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
or