Siemens Sinumerik 840C Diagnostics Manual page 152

1 Alarms
1.5.1 Alarm description
146558 "G%1: exactly one axis expected"
146559 "G63 allowed with G01 only, not with G%1"
146560 "P factor is missing with G51"
146561 "G175 inserted internally because of G%1"
146562 "G175 inserted internally because of @706"
146563 "G175 inserted internally because of D word"
146564 "G%1: only absolute ZO possible with G51"
146565 "@711: Both plane axes are expected"
146566 "@711: G0, G1, G10 or G11 must be active"
146567 "G15: 3 linear and 2 rotary axes expected"
146568 "G%1 is not simulated"
146569 "G%1: No drives programmed"
146570 "G%1: Master drive missing"
146571 "G%1: Max. 1 spindle allowed on master drives"
146572 "G%:1 Slave drive per MD invalid"
146573 "G%1: I,J,K,IKA,IKP for slave drive illegal"
146574 "G%1: Axes, IKA or IKP cannot be simulated"
146575 "G%1: No position for drives allowed"
146576 "G%1: No position for slave drives allowed"
146577 "G%1: Position for slave drive is missing"
146578 "G%1: Position for a master drive is missing"
146579 "G%1: I,J or IKP for master drives illegal"
146580 "G%1: Link. struct. K does not permit IKA word"
146581 "G%1: Linking structure K requires IKA word"
146582 "G%1: IKA word expected due to IKP word"
146583 "G%1: K word not allowed"
146600 "DIN: ... %1 ..."
146700 "G%1 block: too much information in block"
146701 "Block information before jump ignored"
146702 "Block with G92 P: too much info in block"
146703 "Too much information in spline coeff. block"
146704 "Block with G92 T: too much info in block"
146705 "Too much information in block with G92 angle"
146706 "Block with G92 S: too much info in block"
146707 "Block with M19 S: too much info in block"
146708 "Block with @710: too much info. in block"
1–144

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96