ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions page 132

128 | © 2013 ABB | 1SDH001000R0002 - L7804
Continued from the previous page
Parameters
The following figure illustrates parameters that can be the set for the function.
E
D
Figure 84
Pos. Description
A Trigger event
B Stop delay
C Pre-trigger
D Frequency window
E Recording window
Parameters that can be the set and the commands of the function are:
Parameter Description
It selects the number of recordings (1 or 2).
Number of
dataloggers NOTE: the recordings are independent, but they share the
sampling frequency and the type of memory.
Determines the number of data logs recorded.
Sampling IMPORTANT:
frequency • A high frequency allows a more accurate analysis of the
data.
• The higher the frequency, the shorter the recording.
Allows you to set the parameters and to manually command recording
number 1.
• Stop Source: it selects the trigger event, on the occurrence of which
the recording is to be stopped.
• Stop Delay: sets the delay after the trigger event after which
Datalogger 1 recording is to be stopped
• Restart command: starts recording.
• Stop command: stops the recording and saves it in memory.
IMPORTANT: the recording can only be downloaded with
the Ekip Connect application.
The selection of two recordings parameters activates additional commands :
Parameter Description
Datalogger 2 Like Datalogger 1, but relates to recording number 2.
Restart both Starts both the recordings.
Stop Both It stops both the recordings and saves them in memory.
With Ekip Connect software it is possible to select the parameter volatile RAM, not available
on the display, which allows to choose whether to keep the recording also with the release off
(non-volatile) or to delete it if the auxiliary power disappears (Volatile).
NOTE: The parameter is configured by default as non-volatile.
A
C B
Ekip Touch protection release | 14 - Touch measurements
ABB | SACE Emax 2