Ekip Signalling 2K Modules; Description; Compatibility And Power Supply; Electrical Characteristics - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

5 - Ekip Signalling 2K modules

Description The Ekip Signalling 2K is a signalling accessory module.
Compatibility and power supply The modules can be installed in the presence of Ekip Touch, Hi-Touch, G Touch, and G Hi-
Electrical characteristics The following table lists the electrical characteristics of the modules:
185 | © 2013 ABB | 1SDH001000R0002 - L7804
The module has:
• Two digital inputs, and two contacts for output signals.
• A power status LED, and four signalling LEDs (one LED for every input/output).
NOTE: for the positioning of inputs, outputs and LEDs, see the paragraph "Signals
and inputs/outputs", on page 192.
To switch the state of an input, a short circuit must be created between the input, and a
reference available on the same connector. In parallel, the information on the state of the inputs
is transmitted by the module to the release, that can be programmed so that the activation of
an input corresponds to an action on the part of the release.
Instead, the closing or the opening of the contacts is commanded by the release, which can
be programmed so that the closing/opening corresponds to the occurrence of a desired event
or combination of events.
The signalling LEDs light up in the presence of the short circuit for the inputs, or by closing the
contact for the outputs.
IMPORTANT: a maximum of three Ekip Signalling 2K modules can be installed
on the same circuit breaker: one 2K-1, one 2K-2, and one 2K-3. These modules
differ by name and label, and have different wiring, but they are identical in
terms of characteristics and manner of installation.
Touch releases, and require the presence of an Ekip Supply module in the first slot of the
circuit-breaker terminal box.
Component Characteristics
• Maximum switching power
• Maximum switching voltage
• Breaking power
Output contacts
150 V DC, 4A @ 250V AC.
• Dielectric strength between open contacts: 2000 V AC (1 minute
@ 50 Hz).
(1)
Data relating to a resistive load.
: 1250 VA.
(1)
: 150V DC / 250 V AC.
(1)
: 2 A @ 30 V DC, 0.8 A @ 50 V DC, 0.2 A @
(1)
Electronic accessories | 5 - Ekip Signalling 2K modules
ABB | SACE Emax 2