Access From The Display - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

Access from the display With the modules energized, and the Local Bus enabled, the presence of the modules on the
207 | © 2013 ABB | 1SDH001000R0002 - L7804
terminal box activates additional menus on the display:
• In order to set the addressing of the modules.
• In order to display information on the modules.
To enable the Local Bus, you need to select "On" in the menu Settings, Modules, Local Bus.
The following table illustrates the path from the display to set addressing for the modules:
...
Network
frequency
Settings
Modules
Power
Controller
...
(1)
Like the Ekip Com Modbus TCP menu.
The following table illustrates the parameters for setting the addressing of the modules: For
further information, see the table on page 208.
Parameter Selectable values Default
Force Static IP
Off, On
address
Displayed with static IP Address enabled, it must be selected in
Static IP Address
order to insert the IP Address of the modules.
Displayed with static IP Address enabled, it must be selected in
Static Network Mask
order to insert the subnet mask of the modules.
Displayed with static IP Address enabled, it must be selected in
Static Gateway
the presence of multiple subnets, in order to insert the IP Address
Address
of the node to which the modules are connected.
The following table illustrates the path from the display for accessing information on the
modules:
Protection unit
Circuit-breaker
Information
Modules
Power Controller
Local/Remote
Local Bus
...
Ekip Com Modbus TCP
Ekip Com Modbus TCP
*R
...
Function
Description
• Off = Dynamic IP address.
Off
• On = Static IP address.
...
Ekip Com Modbus TCP
Ekip Com Modbus TCP *R
...
Electronic accessories | 9 - Ekip Com Modbus TCP modules
ABB | SACE Emax 2
Force Static IP address
Static IP Address
Static Network Mask
Static Gateway Address
(1)
Continued on the next page