Settings Menu - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

Settings Menu This menu allows you to configure additional settings to those of the protections and of the
69 | © 2013 ABB | 1SDH001000R0002 - L7804
advanced protections and functions.
The following table illustrates the submenus and the parameters associated to the menu
Settings, up to Level 3 (if present). The options corresponding to parameters and commands
are underlined, to distinguish from those corresponding to submenus.
Options
Settings
• Hardware Trip: opens the Edit Parameters page, to enable/disable
opening in the case of hardware problem of the release.
• T Protection: it opens a list of the parameters that can be set for
the overtemperature protection.
• Neutral Protection: available with a configuration with neutral, it
opens a list of the parameters that can be set.
Circuit-breaker
• Earth protection: opens a list of the parameters that can be set.
• Function: allows access to the menu in order to program the
opening action.
• Installation: displayed if a Rating Plug or Ekip Measuring or Ekip
Measuring Pro module is not installed. It opens a list of the modules to
be installed.
Line frequency Opens the Edit Parameters page, to set the Line frequency.
• Local/Remote: opens the Edit Parameters page, to set the local or
remote connection.
• Local Bus: opens the Edit Parameters page, to enable/disable the
Local Bus
• Ekip Measuring, Ekip Synchrocheck, etc: these open a list of the
Modules
(1)
parameters that can be the set for the electronic accessories.
• Function: allows the access to the menus in order to program
Switch On LOCAL, Signalling RESET, YO Command, and YC
Command actions (see the chapter "19 - Operating features", and the
paragraph "Functional specifications", on page 148).
• Enable: opens the Edit Parameters page, to enable/disable the
function.
Power • Load Operating Mode: available with Power Controller enabled,
Controller opens a list of the loads, by enable/disable.
• Power Limits: available with Power Controller enabled, opens a list
of the thresholds of the function to be set.
ABB | SACE Emax 2
Continued on the next page
Ekip Touch protection release | 6 - Menu