ABB IRC5 Operating Manual page 299

Probable causes
The RMQ of the receiving task is not configured for the size of
the data sent. The sending client have sent data that is bigger
than the size the RMQ for task arg can receive.
Recommended actions
Increase the size of the RMQ for task arg. Or, send less data.
Recovery: arg.
41704, RMQ Error - Full Queue
Description
Task: arg.
The client named arg cannot receive more messages.
Program ref: arg.
Consequences
The sent message will be thrown.
Probable causes
The client does not receive in the same pace as the sender is
sending messages. If using instruction arg, you might need a
wait time between each arg instruction.
Recommended actions
The client should receive messages to make room for new
messages. Or the sender should limit the number of messages
sent.
Recovery: arg.
41705, RMQ Error - Max Time Expired
Description
Task: arg.
The programmed waiting time has expired.
Program ref: arg.
Consequences
There is no guarantee that the message has arrived to the client.
Probable causes
The client that should receive the message is not interested of
receiving data of the specified data type. The message has
been discarded. The client has received the message, and in
the answer sent a data type not matching with the specified
data type used in arg of instruction arg.The client has received
the message. The answer is delayed so the time out time for
instruction arg expired.
Recommended actions
Check the client program. Increase the waiting time for
instruction arg.
Recovery: arg.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
41706, RMQ Error - Max Time Expired
Description
Task: arg.
The programmed waiting time has expired.
Program ref: arg.
Consequences
No message has been received.
Probable causes
The time out time for instruction arg expired.
Recommended actions
Increase the waiting time for instruction arg.
Recovery: arg.
41707, RMQ Error - Instruction invalid in current
mode
Description
Task: arg.
arg is only allowed when RMQ is configured in arg mode.
Program ref: arg.
Consequences
The program execution is immediately stopped.
Probable causes
The RMQ is configured in arg mode.
Recommended actions
Change the configuration of the RAPID Message Queue in arg
to arg mode, or use an instruction that is allowed in the current
mode.
41708, RMQ Error - Invalid message
Description
Task: arg.
The received RMQ message was invalid.
Program ref: arg.
Consequences
The received RMQ message was discarded.
Probable causes
A received RMQ message had a corrupt header or data part.
Recommended actions
Recovery: arg.
41711, Value is not percent
Description
Task: arg.
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
Continues on next page
5.6 4 xxxx
Continued
299