Address Setting Check; Polling Led - Panasonic EBL128 Planning Instructions

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: -
15.9
15.10

Address setting check

The red indication LEDs in the detectors 4401 and 4400 will in all
modes be blinking every second when the detector is powered and the
COM loop address is not set with the Address setting tool 3314 /
4414, i.e. as long as the address is "000". The address should be set in
the interval 001-255.
NOTE! 4414 is required when Advanced mode shall be used.

Polling LED

The green polling LED in the detectors 4401 and 4400 can in
Advanced mode be set (via EBLWin) to be blinking (20 ms /
indicating that it receives the commands from the c.i.e. correctly.
NOTE! When the detector is in test mode the green polling LED will
be turned off, indicating it is in test mode.
128
EBL128 Planning Instructions V2.0.x
7 s),